Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Michael Freytag's Discussions (221)

Search Forum

View

Discussions Replied To (218) Replies Latest Activity

"James, The latest beta (version2011.2.22) of Scan&Solve is now available for dow…"

Michael Freytag replied Feb 22, 2011 to Crashing on exit v5

 5 Mar 3, 2011
Reply by Ray McKaig

"James, When there is SnS data attached to the file and our plug-in is loaded, Rhino…"

Michael Freytag replied Feb 22, 2011 to Crashing on exit v5

 5 Mar 3, 2011
Reply by Ray McKaig

"The plug-in can be shared between both V4 and V5 (32-bit).  In V5, load the plug-in…"

Michael Freytag replied Feb 2, 2011 to Latest version not installing on latest V5

 5 Feb 2, 2011
Reply by Michael Freytag

"Lubos, Multiple materials will not make it into Version 1.0, but may be in a WIP of…"

Michael Freytag replied Jan 20, 2011 to Mesh maked by "bake"

 5 Jan 20, 2011
Reply by Michael Freytag

"GP- If this part and loading is symmetric, I would perform analysis on just a quarte…"

Michael Freytag replied Jan 20, 2011 to Framework boat & train

 2 Jan 25, 2011
Reply by Richard.L

"Simon, It is not a typographical error.  When using mm as the length unit in Rhino,…"

Michael Freytag replied Jan 17, 2011 to Torque Value

 1 Jan 17, 2011
Reply by Michael Freytag

"James, I downloaded the latest V5 WIP, and successfully ran the latest version of Sn…"

Michael Freytag replied Jan 16, 2011 to Latest version not installing on latest V5

 5 Feb 2, 2011
Reply by Michael Freytag

"Ghosted and X-Ray are not properly supported yet... I was busy adding torques and bo…"

Michael Freytag replied Jan 16, 2011 to Ghosted and X-Ray view!

 2 Jan 16, 2011
Reply by Simon Klopp

"James, So, the installer is failing, or the plug-in itself doesn't work with V5?  Th…"

Michael Freytag replied Jan 10, 2011 to Latest version not installing on latest V5

 5 Feb 2, 2011
Reply by Michael Freytag

"Germano, Vector force allows you to specify the direction the force is applied.  A s…"

Michael Freytag replied Jan 7, 2011 to Dialog box "Loads"

 1 Jan 7, 2011
Reply by Michael Freytag

RSS

FOLLOW SCAN&SOLVE

© 2025   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service