Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

General (170)

Discussions Replies Latest Activity

Model a simply supported Ramp

Guys,      I find Scan and Solve very easy and intuitive to use. However, modeling a simply supported structure is very counter intuitive.…

Started by Abin P

2 on Saturday
Reply by Abin P

how much hard drive space?

Wondering if there is a rule of thumb for how much hard drive space is required - maybe by the grid resolution or something? I'm working on…

Started by Mike Calvino

3 Jun 28
Reply by Michael Freytag

simulation not finishing?

Any idea why a simulation would not resolve?  I have run this same scenario a number of times before without issue.  Now it gets to 99% and…

Started by Mike Calvino

2 Jun 10
Reply by Aryavrit Travels

specifying units in Material property table in reports

Is there a way to specify the units that are listed in the Material Property Table?  I input properties in the Custom material in IPS, but…

Started by Mike Calvino

3 Apr 12
Reply by Michael Freytag

WIP materials library not keeping values

I am working with the BETA and I have input a number of materials, Stainless steels AISI 316L Sheet, Plate, & 317L Sheet & Plate. …

Started by Mike Calvino

1 Feb 28
Reply by Michael Freytag

Large, thin members, Resolution issue?

I am trying to analyze a thin-member waffle structure.  The overall size is approx. 20'x30', but it is made up (initially) of 20ga. steel s…

Started by Mike Calvino

2 Feb 9
Reply by Will Sixel

How I do convergence test on STL file ?

Well, I am doing the structural analysis on STL file when I am going to Convergence test, is say that polygon error and it is not extruded…

Started by V Phanindra Bogu

7 Dec 9, 2016
Reply by V Phanindra Bogu

hogging and sagging

 I try to calcultae the strength of keel beam But first I have to find the loads and that depends of loads of hogging and sagging. Also it…

Started by Ron de Vos

3 Dec 8, 2016
Reply by Thomas Brandwijk

un-warping warped plastic parts

Hi Scan-and-Solve community, I work with 3d scans of plastic parts in a manufacturing quality and inspection environment.  The scans of re…

Started by Aaron Everman

10 Nov 8, 2016
Reply by Michael Freytag

Stress visulasation

I've lost my colored stress visulasation in Rhino. Were did I go wrong?

Started by Rinus Bos

13 Oct 14, 2016
Reply by Will Sixel

RSS

FOLLOW SCAN&SOLVE

© 2017   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service