Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Hi,
I send you my last exercise I have done,
with a framework simulating the hull of a boat or a passenger car in aluminum workers.
I could not fix a flaw inherent in the modeling of Rhino on the one hand you see a"triangle ", which was also calculated by Scan & Solve.
Question: How do I interpretarte this data?

GP

Views: 364

Attachments:

Reply to This

Replies to This Discussion

GP-

If this part and loading is symmetric, I would perform analysis on just a quarter of the model.  Use Rhino's intersect command with a solid block to isolate the quarter that does not have geometric problems.  Apply partial restraints to the new faces created during the intersection operation:

Also be sure try analysis at different resolutions to get a sense of the convergence behavior, as described here.

 

Hope that helps.

~Michael

It seems that the symmetric restraint can be valid,it's nice.

 

or just keeping only one direction?

RSS

FOLLOW SCAN&SOLVE

© 2020   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service