In Situ Analysis for Rhino
David M's Discussions
Torque Measurement
1 Reply
Could you add a polar measurement (relative to a known point) to the results list when the load is 'Torque'? Best regards, David M …Continue
Started this discussion. Last reply by David M Oct 5, 2011.
David M's Page
Latest Activity
David M replied to Olivier Suire's discussion 'Restraint wish'
"Michael, this is very helpful. I did the above example with very small faces.
Thanks to you and Vadim!
--david"
David M replied to Vadim Shapiro's discussion 'Educational materials and references'
"Vadim, what about some samples using NAFEMS benchmarks that are applicable to S&S' present capabilities?"
David M replied to David M's discussion 'Torque Measurement'
"Vadim, Michael,
Please scratch the above request. After looking at the updates that came with 1.2 I see a much better way. Using *Bake* to output a deflected Rhino mesh allows me to measure the twist (in degrees) at any…"
David M posted a discussion
Torque Measurement
Could you add a polar measurement (relative to a known point) to the results list when the load is 'Torque'? Best regards, David M …See More
David M replied to Olivier Suire's discussion 'Restraint wish'
"This shows what I would be interested in:"
David M commented on David M's video
Bolt
"Here's a comparision (if I had made the mesh a percent finer in Algor, the results would have been even closer):
"
David M commented on David M's video
Bolt
"The restraint is the surface below the head of the fastener and the vector force is applied the the flank of the thread facing the bolt's head.
-David"
Profile Information
- What modeling, simulation and analysis tools do you use?
- Algor
David M's Photos
Comment Wall
- No comments yet!
© 2012 Created by Michael Freytag.
