Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Torque Measurement

Could you add a polar measurement (relative to a known point) to the results list when the load is 'Torque'?

 

Best regards,

 

David M

 

Views: 282

▶ Reply to This

Replies to This Discussion

Permalink Reply by David M on October 5, 2011 at 8:36pm

Vadim, Michael,

Please scratch the above request. After looking at the updates that came with 1.2 I see a much better way. Using *Bake* to output a deflected Rhino mesh allows me to measure the twist (in degrees) at any point.

Thanks!

 

Under 1000 pounds-feet of torque:

RSS

FOLLOW SCAN&SOLVE

© 2025   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service