Scan-and-Solve for Rhino
Simulate Early, Simulate Often... In Rhino
Could you add a polar measurement (relative to a known point) to the results list when the load is 'Torque'?
<![if !IE]>▶<![endif]> Reply to This
Please scratch the above request. After looking at the updates that came with 1.2 I see a much better way. Using *Bake* to output a deflected Rhino mesh allows me to measure the twist (in degrees) at any point.
Under 1000 pounds-feet of torque:
<![if !IE]>▶<![endif]> Reply
Welcome toScan-and-Solve for Rhino
Sign Upor Sign In
© 2023 Created by Michael Freytag.
Report an Issue |
Terms of Service
Please check your browser settings or contact your system administrator.