Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

  • Currently 5/5 stars.

Views: 415


You need to be a member of Scan-and-Solve for Rhino to add comments!

Join Scan-and-Solve for Rhino

Comment by David M on March 7, 2011 at 9:16pm

Here's a comparision (if I had made the mesh a percent finer in Algor, the results would have been even closer):



Comment by David M on March 7, 2011 at 7:52pm

The restraint is the surface below the head of the fastener and the vector force is applied the the flank of the thread facing the bolt's head.



Comment by Vadim Shapiro on March 7, 2011 at 3:37pm
Thank you for posting.   Very nice!    What were the boundary conditions (restraints and loads)?


© 2024   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service