Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Richard.L's Discussions (24)

Discussions Replied To (16) Replies Latest Activity

"Very glad to hear that,It’s very important, of course. Thermal ,thermo-structural an…"

Richard.L replied Jan 25, 2011 to Loads type

4 Jan 26, 2014
Reply by Klaus Stickdorn

"It seems that the symmetric restraint can be valid,it's nice.   or just keeping only…"

Richard.L replied Jan 25, 2011 to Framework boat & train

2 Jan 25, 2011
Reply by Richard.L

"Torque can be available in the next release? That's great! Cancel,Break(Pause) and…"

Richard.L replied Dec 22, 2010 to Some suggestions with the new version!

3 Dec 22, 2010
Reply by Richard.L

"Les, I'm ok with the new  build of Scan&Solve™ for Rhino,Version 2010.12.15.1. T…"

Richard.L replied Dec 18, 2010 to Problem Running Sns

5 Dec 18, 2010
Reply by Les Taylor

"I think i can answer this question. First of all,a solid recognized by Rhino must b…"

Richard.L replied Dec 8, 2010 to Problem Running Sns

5 Dec 18, 2010
Reply by Les Taylor

"Finally,i reviewed this discussion. I agree with you very much,Michael. As to this…"

Richard.L replied Dec 7, 2010 to at last!!

14 Feb 16, 2011
Reply by nick g

"Right! I think so. I’d like discuss with you! 1st,as one case ,S&S do not check…"

Richard.L replied Dec 6, 2010 to A simple test with my cylinder--2

5 Dec 6, 2010
Reply by Richard.L

"Thank you ,Cristian! Your idea is nice, i think the designer or engineer may be ver…"

Richard.L replied Dec 6, 2010 to A simple test with my cylinder--2

5 Dec 6, 2010
Reply by Richard.L

"Thank you,Vadim! Knowing that knack is enough,I think."

Richard.L replied Dec 3, 2010 to A simple test with my cylinder--3

2 Dec 3, 2010
Reply by Richard.L

"Thank you,very glad to hear that."

Richard.L replied Dec 2, 2010 to a simple buckle test

2 Dec 2, 2010
Reply by Richard.L

RSS

FOLLOW SCAN&SOLVE

© 2017   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service