Solving various parts of a model

Replies to This Discussion

Permalink Reply by Vadim Shapiro on January 7, 2011 at 9:35am

It sounds like you would like  to perform structural analysis of the large assembly of parts.    The initial version of Scan&Solve allows analysis of single parts only;   we anticipate adding rudimentary assembly analysis in the near future.    I say "rudimentary" because assembly analysis can get very complex very quickly,  depending on the type of contact (dynamic, sliding, friction, etc.)  at the interface of  the mating parts.    Also large assemblies with many  small members and features may requires much higher resolution with many many elements before the computed results become meaningful.

• ▶ Reply