Simulate Early, Simulate Often... In Rhino
About the tube detail
Hi ：
It is a great powerful tool！I have been waiting a long time for this!!!
thank you very much!!
there are some red point at the middle tube，is it ture？
I think the resolution elements is not enough，Do you think so？
cheers！
Ma SD
Views: 57
Replies to This Discussion
-
Permalink Reply by Vadim Shapiro on
-
Hard to tell from the picture. Could you please post some additional details? The file would be great, but if not, can you tell us what the material, loads and restraints are? Also, did you try running at different resolutions?
Thank you for your comments and posting!
-
Permalink Reply by Ma SD on
-
Mr. Vadim.
Thank you for your attention.
OK. upload file. there 2 files, one is the modle,the other is the material list. but the file too large, it can not upload.
So I post the the loads and restriants condition：
the material:
Steel Q 345 |VonMises |7850 |2.06e+11 |0.33 |3.10e+08 |0 |0 |
I have ran at different resolutions, the more resolutions the more precise. But the more resolution the long time . the resoluions is about 55000, it takes up almost half hour.
Cheers! - Attachments:
-
-
data.rar, 1017 KB
-
© 2025 Created by Michael Freytag.
Powered by
