Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Could you add a polar measurement (relative to a known point) to the results list when the load is 'Torque'?

 

Best regards,

 

David M

 

Views: 275

Reply to This

Replies to This Discussion

Vadim, Michael,

Please scratch the above request. After looking at the updates that came with 1.2 I see a much better way. Using *Bake* to output a deflected Rhino mesh allows me to measure the twist (in degrees) at any point.

Thanks!

 

Under 1000 pounds-feet of torque:

RSS

FOLLOW SCAN&SOLVE

© 2022   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service