Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Can one run a analysis on various solid parts of a model. For example, if I design a boat, i would like to solve the hull + all the frames to analyse the structure.

thanks for the reply

 

Views: 103

Reply to This

Replies to This Discussion

It sounds like you would like  to perform structural analysis of the large assembly of parts.    The initial version of Scan&Solve allows analysis of single parts only;   we anticipate adding rudimentary assembly analysis in the near future.    I say "rudimentary" because assembly analysis can get very complex very quickly,  depending on the type of contact (dynamic, sliding, friction, etc.)  at the interface of  the mating parts.    Also large assemblies with many  small members and features may requires much higher resolution with many many elements before the computed results become meaningful.

RSS

FOLLOW SCAN&SOLVE

© 2024   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service