Simulate Early, Simulate Often... In Rhino
Hi,
I send you my last exercise I have done,
with a framework simulating the hull of a boat or a passenger car in aluminum workers.
I could not fix a flaw inherent in the modeling of Rhino on the one hand you see a"triangle ", which was also calculated by Scan & Solve.
Question: How do I interpretarte this data?
GP
Tags:
GP-
If this part and loading is symmetric, I would perform analysis on just a quarter of the model. Use Rhino's intersect command with a solid block to isolate the quarter that does not have geometric problems. Apply partial restraints to the new faces created during the intersection operation:
Also be sure try analysis at different resolutions to get a sense of the convergence behavior, as described here.
Hope that helps.
~Michael
© 2025 Created by Michael Freytag.
Powered by