Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Hi,

 

I would like to know if scan and solve would do a resonable job simulating wood materials if the mechanical properties are known.

 

I obtained the properties for and average sample of Douglas fir and the max deflection for a 2x6x96 with 100lb force in z and both ends constrained seemed to be way off at 14 inches.

 

I am a novice to  FEA and used the von mises failure model.

 

If scan and solve can simulate wood materials, what would be the best settings in the custom material settings to obtain a reasonable result?

 

Thank you

Craig 

Views: 519

Reply to This

Replies to This Discussion

The current version of Scan&Solve (1.2) is limited to isotropic materials;  these are materials  that have the same mechanical properties in all directions.    Wood has different mechanical properties along each coordinate axis;  it is an example of an orthotropic material.   Wikipedia has a nice picture illustration.     We are currently working on allowing more general materials in Scan&Solve.

I suspected this would be a currently limitation after reading the online documentation

 

Thank you for the prompt reply.

I look forward to future additions

 

You've got a great product here.

 

Can you suggest any recommended reading for newcomers to FEA?

Something digestable by the layman?

 

Regards

Craig

 

Craig

I think that your question is of general interest,  so I started a new thread in the forum answering your question.

RSS

FOLLOW SCAN&SOLVE

© 2021   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service