Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Hi,
I have tried to do some more tests, but SnS doesnt start with selected polysurface?
Something wrong with a solid created with Command: _CreateSolid ?
 I am sending 3dm for some more experienced to scan.
Model is far from construction model, but is it possible to test some complex construction.
I see here more problem for me to make solid prepared for test, is there a complexity limit for
polysurface-solid  for Sns?

Zoran

Views: 50

Attachments:

Reply to This

Replies to This Discussion

Hi Zoran,

I have rebuild your model, it seems like one end cap was not closing the tube properly. Here is the corrected model without those two circular cut-outs. I have tried it out and it was recognized by SnS.

Cheers,

Hrvoje.
Attachments:
Hi Hrvoje,
thanks for rebuilding it , but I cannot take your rar file:
-----------------------------------------------------------------
You don't have permission to access "http://storage.ning.com/topology/rest/1.0/file/get/2506640187?profile=original" on this server.

Reference #18.9184bfd5.1286779552.36ef9e7
I am properly signed in.
-----------------------------------------------------------------
zoran@bifstudio.com
I have sent you a mail with the file.

Cheers,

Hrvoje.

RSS

FOLLOW SCAN&SOLVE

© 2024   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service