Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Hello all,

I am using scan n solve for calculating load on linear system in rhino.

The moment I increase my node number it stops responding and rhino crashes.

Is there any way I can stop frm that to happen.

A purge command or something

Arya

Views: 398

Reply to This

Replies to This Discussion

Hello Arya,

Is there anything unusual about the geometry you're trying to simulate?

You might try deleting the simulation from the scenario selector you get when you run the SnSPro command.  If that doesn't work, if you send us the .3dm file, we can take a look.

Michael

RSS

FOLLOW SCAN&SOLVE

© 2024   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service