Simulate Early, Simulate Often... In Rhino
Partial model results
I have done an analysis of a portion of a steel vessel. The analysis seemed to go well but the results seem incomplete and patch. The attached picture shows the issue.
The analysis is running on windows7 pro 64 bit. I have done other studies that work fine but sometimes this error occurs. Are then any adjustments that can be done to the settings to rectify this?
Any advice welcome.
Thanks
paul
Views: 211
Replies to This Discussion
-
Permalink Reply by Michael Freytag on
-
Hello Paul,
I've never seen this before. It has the appearance (but not exactly) of inadequate resolution in the Z-buffer of your graphics card. Do you see different triangles popping into and out of existence as you change the view orientation?
~Michael
© 2025 Created by Michael Freytag.
Powered by
