Simulate Early, Simulate Often... In Rhino
After running 'GO!' I cannot click on 'View' or 'About' tabs
Any ideas people. after running a full 'GO!' there is not response from clicking on the other tabs.
Having just wrote this I have found a solution: Using a split screen / multi screen the 'tabs' cannot be toggled when the pop up window is in the second screen and not the master...
Views: 38
Replies to This Discussion
-
Permalink Reply by Simon Klopp on
-
Yes, I have the same problem. If I choose a high resolution, or a quite complex solid, the calculations will run quite long. And there is no chance to stop this calculation. The "cancel" button will not work...
Only sollution is to completely close the Rhino programm and create an abnormal end!
Simon
© 2024 Created by Michael Freytag.
Powered by
