Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Ian Boyd's Discussions (26)

Discussions Replied To (17) Replies Latest Activity

"Yes, that helps, thanks! The application is adhesive tape on a wall. The load is a P…"

Ian Boyd replied Nov 11, 2014 to Stress XX, XY etc.

2 Nov 11, 2014
Reply by Ian Boyd

"Hi Michael OK, sounds good. I'm teaching at Plastics|SA the whole of this week but s…"

Ian Boyd replied Nov 10, 2013 to Export SNS solution as 3D PDF with SimLab plug in

6 Nov 10, 2013
Reply by Ian Boyd

"Hi Michael Fantastic, thanks! I'm very excited about the prospect of allowing SnS to…"

Ian Boyd replied Nov 8, 2013 to Export SNS solution as 3D PDF with SimLab plug in

6 Nov 10, 2013
Reply by Ian Boyd

"Hi Michael It has undergone a redesign with honeycomb in the center - I have found…"

Ian Boyd replied Oct 31, 2013 to Export SNS solution as 3D PDF with SimLab plug in

6 Nov 10, 2013
Reply by Ian Boyd

"Hi Rendy The prototype looking good! 8mm steel for back - no problem - if you run in…"

Ian Boyd replied Nov 22, 2011 to Office Chair Analysis

10 Mar 27, 2012
Reply by skyma

"Hi Rendy   (Sorry for taking so long to reply... a bit hectic here). It's a good thi…"

Ian Boyd replied Nov 2, 2011 to Office Chair Analysis

10 Mar 27, 2012
Reply by skyma

"Excellento! - Thanks Vadim! Ian"

Ian Boyd replied Oct 28, 2011 to Educational materials and references

5 Oct 28, 2011
Reply by Ian Boyd

"Adding to my own post...   I was being silly - there was no need to export/import th…"

Ian Boyd replied Oct 28, 2011 to Dauphin - Rendering SnS Results with V-Ray

1 Oct 28, 2011
Reply by Ian Boyd

"Hi Rendy   For the US standard on chairs you need to look up Ansi-BIFMA, X5.1 (backr…"

Ian Boyd replied Oct 28, 2011 to Office Chair Analysis

10 Mar 27, 2012
Reply by skyma

"Hi Liam   To illustrate my point in last response regarding assembly stresses. Desig…"

Ian Boyd replied Aug 24, 2011 to Accuracy.....

3 Aug 24, 2011
Reply by Ian Boyd

RSS

FOLLOW SCAN&SOLVE

© 2024   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service