Simulate Early, Simulate Often... In Rhino
Simon Klopp's Discussions
Torque Value
1 Reply
Hello SnS team! If possible, can you please change the torque value from N.mm into the normal N/m SI unit. This would be much easier to work with...…Continue
Started this discussion. Last reply by Michael Freytag Jan 17, 2011.
Ghosted and X-Ray view!
2 Replies
Hello SnS team!I´ve done the first tests on the new (pre relase) version. I see that you have designed a torque load, but I haven´t tested it unitl now! What I have done is to test out the Ghosted…Continue
Started this discussion. Last reply by Simon Klopp Jan 16, 2011.
Some suggestions with the new version!
3 Replies
I did some test with the new version. Altogether, I´m very happy with this new version! You have done a quite good design work! Some suggestions from my side:If the calculations start running, there…Continue
Started this discussion. Last reply by Richard.L Dec 22, 2010.
Compact installer don´t work
2 Replies
Hello all! I´ve tried to install the update of the lastest SnS on my computer, using the Compact Installer! Certainly, this is not a major problem that should be discussed here, but I think that the…Continue
Started this discussion. Last reply by Simon Klopp Dec 21, 2010.
Simon Klopp's Page
Profile Information
- Occupation
- Professional
- Website Address
- http://www.picohydropower.com
- What modeling, simulation and analysis tools do you use?
- Rhino
Simon Klopp's Photos
© 2024 Created by Michael Freytag.
Powered by
Comment Wall
You need to be a member of Scan-and-Solve for Rhino to add comments!
Join Scan-and-Solve for Rhino