Simulate Early, Simulate Often... In Rhino
Solving various parts of a model
Can one run a analysis on various solid parts of a model. For example, if I design a boat, i would like to solve the hull + all the frames to analyse the structure.
thanks for the reply
Views: 18
Replies to This Discussion
-
Permalink Reply by Vadim Shapiro on -
It sounds like you would like to perform structural analysis of the large assembly of parts. The initial version of Scan&Solve allows analysis of single parts only; we anticipate adding rudimentary assembly analysis in the near future. I say "rudimentary" because assembly analysis can get very complex very quickly, depending on the type of contact (dynamic, sliding, friction, etc.) at the interface of the mating parts. Also large assemblies with many small members and features may requires much higher resolution with many many elements before the computed results become meaningful.
© 2013 Created by Michael Freytag.
