Simulate Early, Simulate Often... In Rhino
solid
Hi,
I have tried to do some more tests, but SnS doesnt start with selected polysurface?
Something wrong with a solid created with Command: _CreateSolid ?
I am sending 3dm for some more experienced to scan.
Model is far from construction model, but is it possible to test some complex construction.
I see here more problem for me to make solid prepared for test, is there a complexity limit for
polysurface-solid for Sns?
Zoran
I have tried to do some more tests, but SnS doesnt start with selected polysurface?
Something wrong with a solid created with Command: _CreateSolid ?
I am sending 3dm for some more experienced to scan.
Model is far from construction model, but is it possible to test some complex construction.
I see here more problem for me to make solid prepared for test, is there a complexity limit for
polysurface-solid for Sns?
Zoran
Views: 52
- Attachments:
-
-
test_02.3dm, 1.4 MB
-
Replies to This Discussion
-
Permalink Reply by Hrvoje Petrovic on
-
Hi Zoran,
I have rebuild your model, it seems like one end cap was not closing the tube properly. Here is the corrected model without those two circular cut-outs. I have tried it out and it was recognized by SnS.
Cheers,
Hrvoje. - Attachments:
-
-
test_02 correction.rar, 377 KB
-
-
Permalink Reply by Zoran on
-
Hi Hrvoje,
thanks for rebuilding it , but I cannot take your rar file:
-----------------------------------------------------------------
You don't have permission to access "http://storage.ning.com/topology/rest/1.0/file/get/2506640187?profile=original" on this server.
Reference #18.9184bfd5.1286779552.36ef9e7
I am properly signed in.
-----------------------------------------------------------------
zoran@bifstudio.com
-
-
I have sent you a mail with the file.
Cheers,
Hrvoje.
© 2024 Created by Michael Freytag.
Powered by
