Scan-and-Solve for Rhino

Simulate Early, Simulate Often... In Rhino

Why sns use only half cpu?

Are some setting to change?

Marco

Views: 237

Reply to This

Replies to This Discussion

Hello Marco,

There are no settings in Scan&Solve to adjust the processor utilization.  The code is only parallelized in the computationally-intensive section where Scan&Solve reports "Building linear system."  Even there, processor utilization can depend on MANY factors including processor brand, model, memory size, simulation size, operating system, other program activity, BIOS settings, etc.  Your BIOS settings for enabling/disabling hyperthreading MAY make a difference.

Michael

RSS

FOLLOW SCAN&SOLVE

© 2024   Created by Michael Freytag.   Powered by

Badges  |  Report an Issue  |  Terms of Service