Simulate Early, Simulate Often... In Rhino
A simple test with my cylinder--3
Finally, i have some time to continue my cylinder test series as expected.
Here‘s the simple test, compared between Abaqus and S&S.
The same conditions as fellows;
1.Model .stp from the same geometry
2.Material both use the S&S default steel
| Description | Steel, Stainless (ferritic) |
| Density | 7.8e-09 Mg/mm3 |
| Elastic Modulus | 200000 MPa |
| Poisson Ratio | 0.28 |
3. the loads&BCs
10Mpa pressure at the left outside surface，fixed at the inner circular surface.
for Abaqus,
for S&S
4.Elements(resolution)
Abaqus 71,682 HEXA
S&S 68,000
5.Results
6.Summary
Over all，it's acceptable,and all the rainbow graphs mached very well,considered the
'Finite element' methods.
I wish i can point out the maximu displacement& von mises stress location accurately in the model graph.
The comment was already in the report,
| Maximum | 0.370057 | {3.85924,28.6545,-15.4625} |
but it's not very difficult to add a button for the option, i think.
Thanks.
Views: 451
Replies to This Discussion
-
Permalink Reply by Vadim Shapiro on
-
Double click on the max value at the end of the color bar. This will show you the location of the max for whatever it it is you are looking at. We are working on additional visualization utilities.
© 2024 Created by Michael Freytag.
Powered by
