Mon Sep 12, 2011
16:37:36
Geometry
Geometry Summary
Quantity | Unit |
Volume | 1.96856e+06 mm3 |
Surface Area | 358011 mm2 |
Mass | 0.00275598 Mg |
Bounding Box |
min. corner | {-236.966,-9.18565e-14,307.77} |
max. corner | {236.976,169.285,976.616} |
Material Properties
Property | Value |
Description | Nylon 610 |
Density | 1.4e-09 Mg/mm3 |
Elastic Modulus | 8300 MPa |
Poisson Ratio | 0.28 |
Default Failure Criterion | von Mises |
Tensile Yield Strength | 139 MPa |
Loads & Restraints
Load Summary
Description | Type | Definition |
Load 1 | Scalar Force | 10000 N |
Restraint Summary
Description | Definition |
Restraint 1 | X-Fixed,Y-Fixed,Z-Fixed |
Simulation Summary
Settings
Basis Functions |
Degree | 1 |
nx | 62 |
ny | 23 |
nz | 87 |
Element size | {7.81531,7.81531,7.81531} |
Resolution setting | 9985 |
Computation Box |
min. corner | {-242.207,-5.1956,302.281} |
max. corner | {242.342,174.556,982.213} |
Units
Quantity | Unit |
Length | mm |
Mass | Mg |
Force | N |
Time | s |
Simulation Results
Displacements
Displacement Summary
| Amount | Location |
Minimum | 4.30297e-09 mm | {0,17.7007,321.351} |
Maximum | 147.971 mm | {3.0706e-13,127.04,976.616} |
Danger Level
Danger Level Summary
| Amount | Location |
Minimum | 2.03714e-07 | {-55.6888,3.68073,309.568} |
Maximum | Criterion Limit Exceeded | {-206.083,50.5085,474.228} |
Results Extrema
| Minimum | Maximum |
X-Displacement | -17.5538 mm | 17.5677 mm |
Y-Displacement | -0.182513 mm | 145.839 mm |
Z-Displacement | -26.7806 mm | 22.0152 mm |
Total Displacement | 4.30297e-09 mm | 147.971 mm |
Von Mises Stress | 2.83162e-05 MPa | 499.438 MPa |
Max. Principal Stress | -77.1091 MPa | 568.185 MPa |
Mid. Principal Stress | -124.87 MPa | 126.559 MPa |
Min. Principal Stress | -349.066 MPa | 97.8552 MPa |
Danger Level (von Mises) | 2.03714e-07 | Criterion Limit Exceeded |
Danger Level (Max. Shear Stress) | 4.61244e-07 | Criterion Limit Exceeded |
CAUTION
Design decisions require experimental data and substantial experience; they should never be made based solely
on a software simulation. Simulation is not intended to replace physical testing of prototypes, which is required
to validate any design.